User`s guide

8. On the WAP Settings menu,
scroll to 1>Primary IP and press
the OK key to Edit.
Use the number keys to enter
the PC IP address. (To find your
PC IP Address:
•for Windows 98 see
step 2.2.3.1-j.
•for Windows 2000 see
step 2.2.3.2-i.)
This tells the phone where to
find its primary server. Use the
left arrow (*) and right arrow
(#) keys to move among the
numbers. Use the C key to clear
(or delete) a number.
Note: On the Motorola Timeport
phone, you must insert leading zeros
so the IP address consists of 12
numbers. The decimal points
between the numbers are entered
automatically by the phone for this
specific function.
Example:
If your PC IP address 111.222.33.6
Enter this in the Motorola
Timeport phone 111.222.033.006
9. Write the IP address you
entered in the phone here:
10. Press the OK key when finished.
11. Also on the WAP Settings menu,
scroll to 2>Primary Port and
press the OK key to Edit.
12. Under Enter Port:, edit the
number to 9201. This is the
default value, and should
already be in the data field.
Press the OK key when finished.
13. Press the C key to return to the
Profile menu.
14. On the Profile menu, scroll to
2>Data Bearer and press the OK
key to Edit.
15. Scroll to 1>GPRS. This is the
default value, and should
already be in the data field.
Press the OK key to Edit. It is
OK if the APN, username, and
password are all blank.
16. Press the C key three times to
return to the Browser Menu.
Use the scroll key to move to the
top of this menu.
17. If you are using the Infinite
WAPlite Gateway software in
Appendix A: Installing a WAP
Gateway into a PC, follow these
steps to set the phone’s browser
to find the WAPLite homepage
on your PC. (If not, skip to
step 18 below.)
a. Scroll to 2>Web Favorites and
press OK.
b. Scroll to choose an unused
http Web address (or
overwrite an old one).
c. Press the Menu (Edit) key.
d. Under “Enter URL:”, enter
http://local/waplite.wml.
Editing addresses like this is
an awkward process on the
phone, because you must
switch among the alphabetic,
numeric, and multiple symbol
menus to enter all of the
characters. Be patient. (Press
the Menu key to switch
among alpha, NUM, and SYM
key sets. While on a SYM set,
press the OK (SYM) key to
select among SYM1, SYM2,
SYM3, and SYM4 character
sets).
e. Press the OK key when
finished.
18. Press the lowest button on the
left side of the phone to exit the
phone’s browser (the upper
buttons are the volume
controls). You will see the
phone’s turn-on display (usually
shows “001-01”). The phone is
still attached.
19. Turn the phone off. Note: After
you turn off the phone, you
typically cannot turn it back on
for about ten seconds.
20. Setup is complete.
If you adjust IP addresses for the
demonstration, remember to set
them back to the original settings
when the demonstration is finished
so that the devices will work on
their normal networks.
11