User`s guide

If the phone does not show service,
check the phone for a label indicat-
ing a different cell band or broad-
cast channel, and enter those into
the test set. Check that the phone’s
band matches the test set's cell
band.
4. For the Motorola Timeport
phone, press the phone’s Menu
key briefly.
a. Scroll to Network Selection
with the up/down arrow key.
b. Press OK key to View
Options? (The phone should
display “Change Band”.)
c. Press OK key to View Options?
d. Scroll to “Change to
900/1800”.
e. Press OK key to Select? If
the phone still doesn’t show
service, look in Appendix B:
Troubleshooting.
2.2.6 Modifying phone settings
To demonstrate data connection
functions, the phone settings must
be modified. Note: Some older
versions of Motorola Timeport
phones may lose the IP address
entered in this section. Check this
whenever you turn on the phone.
1. After the phone is attached,
press the phone’s Menu key
briefly.
2. When the display shows “Access
Internet / Select?”, press the OK
key to select.
3. Hold down the Menu key for
about three seconds and release.
4. On the Browser Menu, scroll to
7 >Setup with the up/down
arrow key and press OK. If the
phone hasn’t been setup yet, it
will display a list of profiles
such as “profile1”. Use the
up/down arrow key to highlight
profile1 (or another unused
profile location), or overwrite a
previous profile.
5. Press the OK (Sel) key, then
wait a few seconds until the
phone returns to the profile
menu.
6. Press the Menu (Edit) key.
7. On the profile1 menu, scroll to
1>WAP Settings and press the
OK key to Edit.
2.2.5 Verify GPRS attach function
Verify your phone or wireless
appliance will perform a GPRS
attach using the procedures below.
These instructions assume you are
using a Motorola Timeport 260
Series GPRS Mobile Phone. Other
devices will require similar setups,
often found under the Menu struc-
ture of the phone in the WAP
Settings section. If necessary, follow
the phone manufacturer’s instruc-
tions to install the test SIM into the
phone or wireless appliance.
1. Turn on the phone or wireless
appliance. The phone should
indicate service signal-strength
bars (in the upper left corner of
the display) within about one
minute.
2. It should also indicate
the numbers “001-01” or the
word “TEST” in the center of the
display (this is the default test
network number stored in the
test set).
3. On the test set, in the bottom
center of the display, the Active
Cell box should show:
“Attached”. If it does, skip to
section 2.2.6.
10