User`s guide
Copyright 2002 Agilent Technologies. 10001809-E6701A Tutorial Direct Connection
All Rights Reserved.
Page 12 of 30 Rev. 1.0; Feb. 19, 2002
5. In the Subnet Mask: field, we recommend you set the PC’s subnet mask
to
255.255.255.0
6. Select OK, then OK again to exit the Network menu
7. If you made changes, a System Settings Change box will appear. Select
the Yes box to Restart your PC.
Windows 2000
This procedure assumes you are using a standalone PC (not connected to a network) using
the Microsoft Windows 2000 operating system. Other PC configurations may use slightly
different setups.
1. Go to the Control Panel
2. Choose the Internet Options icon
a. Select the Connections tab
b. Select the LAN Settings box
c. In the “Automatic configuration” section, both “Automatically detect settings”
and “Use automatic configuration script” must NOT be checked.
d. In the “Proxy server” section, “Use a proxy server” must NOT be checked.
e. Select OK, then OK again to exit the Internet Options menu
3. Choose the Network and Dial-up Connections icon
a. Select the Local Area Connection icon
b. Select Properties
c. Highlight “Internet Protocol (TCP/IP)”
i. Select Properties
ii. Select “Use the following IP Address”
iii. Write down the original IP address here (in case you want to restore
the original settings):
PC’s original IP address: _________________________________
iv. Enter almost the same address as the Test Set’s LAN IP Address (see
step 3.2.3.2 above), except change the 4
th
set of digits to an integer
between 1 and 254. Enter it in the field labeled IP Address.
Example: Test Set IP Address = 111.222.33.224
Set the PC IP Address= 111.222.33.222
v. Write down the NEW IP address here:
PC’s NEW IP address: _________________________________
IMPORTANT: The DUT IP Address, the Test Set ‘s LAN IP Address, and
the PC IP Address cannot be the same. Also, do not set the 4
th
set of
numbers to 0; and do not set the 4
th
set of numbers greater than 254. (In the
example above, the 4
th
set of numbers is set to “222”.)
d. In the Subnet Mask: field, we recommend you set the PC’s subnet mask to
255.255.255.0
e. Select OK, then OK again to exit the Network menu