User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
88
PHY Settings
Accesses the physical layer parameters available to you for configuration.
Cell ID
PHICH Resource
CFI
CFI (Normal SF)
CFI (Special SF)
UL Resource Allocation
DL Resource Allocation - Key Menu 1
DL Resource Allocation - Key Menu 2
Key Path: BSE > Mode Setup > More
Cell ID
Sets the Physical Layer Cell Identity as defined in 3GPP 36.211, referred to as
cell
ID
N
.
Mode
BSE
Range
0 to 503
Preset ACELL = 0
BCELL = 2
Initial S/W Revision
6.1
Key Path
Mode > BSE > Mode Setup > More > PHY Settings
PHICH Resource
The PHICH Resource helps determine the number of PHICH groups that are used. (See 3GPP 36.331 -
PHICH-Config.)
Normally, this parameter is determined by the equivalent setting inside the Master Information Block in
the loaded scenario file created using the N6062A Protocol Message Editor software. If you select the
value using this menu key, it will be overwritten when you load the scenario file.
Mode
BSE
Range
1/6 | 1/2 |1|2
Preset ACell = 1
BCell = 1
Initial S/W Revision
6.1
Key Path
Mode > BSE > Mode Setup > More > PHY Settings