User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
85
Mode Setup (BSE Mode)-Key Menu 1
Accesses the available parameters you can set to configure the BSE mode.
Call Scenario
EPC
Control Mode
CH Bandwidth
C-RNTI
Key Path: Front-panel key
Call Scenario
Accesses the Change Directory/Load, Unload, and Delete options available for scenario files created using
the N6062A Protocol Message Editor software.
Key Path: Mode > BSE > Mode Setup
Change Directory/Load
Change Directory: If the instrument is highlighting a directory, you can access a new directory level using
the up/down arrow keys on the front-panel. Pressing this key selects the highlighted directory.
Load: If the instrument is highlighting a scenario file, pressing this key activates this file.
Mode
BSE
Initial S/W Revision 6.0 (Load available in 6.0)
6.3 (Change Directory available in 6.3)
Key Path
Mode Setup > Call Scenario
Unload
Deactivates the loaded scenario file.
Mode
BSE
Initial S/W Revision
6.3
Key Path
Mode > BSE > Mode Setup > Call Scenario
Delete
Deletes the selected scenario file.
Key Path: Mode > BSE > Mode Setup > Call Scenario
EPC
The Evolved Packet Core (EPC) in the E6621A is an abbreviated version of the LTE EPC. It is responsible for
IP traffic routing – accepting uplink IP data from the UE and putting it on to the network. Similarly for the
downlink, it acts as a proxy for UE IP addresses, accepting and forwarding IP data to the stack.
Off: Set EPC off when you are doing RF transmitter or receiver measurements.
Embed: Use this setting when you are doing end-to-end functional tests.