User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
78
b. The setting of Amp > Output Power Offset. For example, when this is set to 10dB, the Amp >
Amplitude setting is boosted by 10dB, which means the UE sees an RSTP value that is 10 dB
higher and reports a 10 dB higher RSRP. See Amp > RF1 Output Power Offset on page 8
for more
information.
c. Any errors from the DL signal level.
d. Any other measurement errors.
BSE Information
Refer to BSE Information
on page 71 for descriptions of the information displayed here.
UE Information
Field
Description
Random value
Provided by UE in RRC Connection Request message. If never connected to
network before, it sends this random value. If has been connected to the network
before, the S-TMSI is assigned.
S-TMSI
SAE (System Architecture-Temporary Mobile Subscriber Identity
IMSI
International Mobile Subscriber Identity – See IMSI value on page 134.
C-RNTI
Cell-Radio Network Temporary ID – See C-RNTI on page 92 for the UL description
and page 105 for the DL description.
PUCCH TPC-RNTI
This field displays the PUCCH TPC-RNTI value assigned to the UE in the RRC
Connection Setup message. Adjustment of PUCCH power levels using DCI 3 or 3A
messages is not currently supported.
PUSCH TPC-RNTI
This field displays the PUSCH TPC-RNTI value assigned to the UE in the RRC
Connection Setup message. See the UE Power Control section on page 43 to learn
how to send DCI 3/3A messages to adjust the PUSCH power level.
UE Category This field displays the UE Category reported by the UE inside the UE Capability
Information message. This represents the capabilities of the UE as described in
3GPP TS 36.306.
Access Stratum Release This field displays the Access Stratum release reported by the UE in the UE
Capability Information message. This will correspond to the release of the 3GPP
standards that the UE adheres to.
Key Path: Mode > BSE > Meas