User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
56
Notes
SCPI command returns the name of the specified CUSTOM message
Key Path
Mode > BSE > Func > Custom Messages
Measurement Report
Measurement Reports only exist here if you have created them using the N6062A Protocol Message
Editor software on the Extended tab. Refer to Measurement Report
on page 76 for more information.
Key Path: Mode > BSE > Func > Custom Messages > Message Name
Custom Messages Mode
In previous releases of PXT firmware, each measurement report had to be set up in the scenario file. In
order to reduce the number of scenario’s, it is now possible to overwrite the default scenario file
measurement item with this setting. The default setting in these scenarios is the center EARFCN for Band
17, so if you are using Band 17 there is no difference between the Default
setting and the Serving Cell
setting. If however, you wish to test in any other band at any other EARFCN, then always set this setting
to Serving Cell
.
Mode
BSE
Range
Default | Serving Cell
Preset
Default
Dependencies and/or Couplings
Initial S/W Revision
6.4
Key Path
Mode >BSE > Func > Custom Messages
PDCCH Order
Accesses the menu that enables the sending of a PDCCH order. The functions in this menu are not
available in TDD.
Key Path: Mode > BSE > Func
Send PDCCH Order
Sends a PDCCH Order message (a special type of a DCI1A message) containing a PRACH Mask Index of 0
and a Preamble Index of 1.
The PDCCH order is sent on a PDCCH masked with the C-RNTI value (set by selecting Mode Setup on the
PXT front-panel) and in the UE specific search space.
To respond to this PDCCH order, the UE must be in an RRC Connected state. The BSE can send the PDCCH
order if the UE is not RRC Connected – but it is not detected by the UE.
Mode
BSE, FDD
Initial S/W Revision
6.0
Notes
This key is primarily useful when performing Radio Conformance
Testing.
Key Path
Mode > BSE > Func > PDCCH Order