User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
54
The PXT saves this data for up to one second or until the UE reaches the RRC Connected state (CON).
When the UE is connected, the data that has prompted the paging process (and all subsequent data that
has arrived since) is sent to the UE. If the UE does not reach the CON state within one second, the queued
data is discarded.
Each IP packet that arrives during this one second period does not prompt a new
paging message to be sent. Only one paging message is sent during this one
second period.
Mode
BSE
Range
On | Off
Preset
Off
Dependencies and/or Couplings
You must have a scenario file that includes Paging messages.
Initial S/W Revision
6.5
Notes If the EPC is forwarding data to the 8960 (for example the UE is connected
to 3G), the paging procedure is not initiated.
Key Path
Mode > BSE > Func > Paging
Send
Sends the specified Paging message from the list displayed when you press Mode > BSE > Func > Paging
> Message Name.
Key Path: Mode > BSE > Func > Paging
Message Name
Enables you to select the message you wish to send from the list of Paging messages you defined in the
currently loaded scenario file.
Messages shown here are those you created using the N6062A Protocol Message
Editor software on the “Extended” tab.
Mode
BSE
Dependencies and/or Couplings
You must have a scenario file that includes Paging messages.
Initial S/W Revision
6.1
Notes
SCPI command returns the number of CUSTOM messages available.
Key Path
Mode > BSE > Func > Paging
Custom Messages
Accesses the Send and Message Name functions. For example, this is where you would find a
Measurement Report custom message you created using the N6062A Protocol Message Editor software, as
shown below.