User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
53
UE Detach
Accesses the Send and Message Name functions. This is the “Release Message” box shown on the
Extended tab of the N6062A Protocol Message Editor software tool.
Mode
BSE
Dependencies and/or Couplings
You must have a scenario file that includes UE Detach messages.
Initial S/W Revision
6.1
Notes
SCPI command returns the number of DETACH messages available.
Key Path
Mode > BSE > Func
Send
Sends the specified UE Detach message from the list displayed when you press Func > UE Detach >
Message Name.
Mode
BSE
Initial S/W Revision
6.1
Key Path
Mode > BSE > Func > UE Detach
Message Name
Enables you to select the message you wish to send from the list of UE Detach messages you defined in
the currently loaded scenario file.
Messages shown here are those you created using the N6062A Protocol
Message Editor software tool on the “Extended” tab.
Mode
BSE
Range
1-8
Dependencies and/or Couplings You must have an active scenario file that includes UE Detach
messages.
Initial S/W Revision
6.1
Notes
SCPI command returns the name of the specified DETACH message.
Key Path
Mode > BSE > Func > UE Detach
Paging
Accesses the Send and Message Name functions.
Key Path: Mode > BSE > Func
Auto Paging
If the UE is in RRC Idle (IDLE) state, and the EPC receives data that is intended to be sent to any of the IP
addresses (either IPv4 or IPv6) that are currently in use, the PXT sends the first paging message in the
Paging message list.