User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
44
Power Control Mode
Sets the control of the UE power to manual or CLPC (Closed Loop Power Control).
Refer to CLPC and Closed Loop Power Control – More information.
Mode
BSE
Range
Manual | CLPC
Preset
Manual
Dependencies and/or Couplings
UE must be connected.
Power Adjust (All Up) or Power Adjust (All Down) must be Off in order
to set this feature to CLPC
.
Selecting CLPC
automatically sets Atten > Attenuation = Adaptive.
Initial S/W Revision
6.4
Key Path
Mode >BSE > Func > UE Power Control
Manual
Accesses the settings shown below that set the UE power control when the Power Control Mode key is
set to ‘Manual’.
Send Message
DCI Format
Power Adjust (Accumulated)
Power Adjust (Absolute)
Power Adjust (DCI3A)
Mode
BSE
Dependencies and/or Couplings
Power Control Mode key must be set to ‘Manual’
Initial S/W Revision
6.4
Key Path
Mode > BSE > Func > UE Power Control
Send Message
Pressing this key sends a single DCI message, using the format you selected using the DCI format key.
See Func >
UE Power Control > DCI Format. These messages are used to control the UL power used by the UE.
Key Path: Mode >BSE > Func > UE Power Control
DCI Format
(Downlink Control Information) format determines which DCI message is sent when the Send Message
menu key is pressed. The options available are: 0, 1A, 3, and 3A. (See Power Adjust (DCI3A)
for more
information on option 3A).