User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
42
Transfer Rate
Maximum: Enables you to send the maximum number of packets in the DTCH test. (Approximately 50
packets per second (pps))
Manual: Use this setting if you want to test data by sending packets at a slower rate.
Mode
BSE
Range
Maximum | Manual
Preset
1 pps
Initial S/W Revision
6.0
Key Path
Mode > BSE > Func > DTCH Test > Parameter
Format
RAW: When selected, the data format is random, based on the Pseudo Random Binary Sequence (PRBS).
ICMPv4: When selected, the data format used is that required for the internet layer. (Internet Control
Message Protocol version 4)
UDPv4: When selected, the data format used is that required for the transfer layer.
Mode
BSE
Range
RAW | ICMPv4 | UDPv4
Preset
UDPv4
Initial S/W Revision
6.0
Key Path
Mode > BSE > Func > DTCH Test > Parameter
Payload Type
Accesses the menu that enables you to select three payload types: Random, Incremental, and User Define.
Mode
BSE
Range
Random | Incremental | User Define
Preset
Random
Initial S/W Revision
6.0
Key Path
Mode > BSE > Func > DTCH Test > Parameter
Random
For UDPv4 and ICMPv4, this setting enables random data to be carried inside the data packet. This is the
preset value.
Key Path: Mode > BSE > Func > DTCH Test > Parameter > Payload Type