User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
40
Parameter (Key Menu 1)
Enables you to access parameter settings to define the data throughput.
Ipv4 Setting
UDP Setting
Transfer Mode
Transfer Rate
Format
Payload Type
Key Path: Mode > BSE > Func > DTCH Test
Ipv4 Setting
The Internet Protocol version 4 (IPv4) setting enables you to set the source and destination address for
this IP network protocol. This enables you to send “ping” packets to the UE.
To activate this function, you must select IPv4 by pressing Func > DTCH Test > Parameter > Format until
one of the IPv4 options is underlined.
Key Path: Mode > BSE > Func > DTCH Test > Parameter
Source address
Sets the IPv4 source address.
Do not use the remote command for this setting over the LAN, only via GPIB.
Mode
BSE
Preset
“0.0.0.0”
Initial S/W Revision
6.0
Key Path
Mode > BSE > Func > DTCH Test > Parameter > IPv4 Setting
Dest Address
Sets the IPv4 destination address.
Do not use the remote command for this setting over the LAN, only via GPIB.
Mode
BSE
Preset
“0.0.0.0”
Initial S/W Revision
6.0
Key Path
Mode > BSE > Func > DTCH Test > Parameter > IPv4 Setting