User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
35
Initial S/W Revision
6.0
License Type E6621A-503 = 350 MHz to 3 GHz
E6621A-506 = 350 MHz to 6 GHz
Key Path
Freq
Center (UL/DL) Freq
Sets the UL and DL center frequency to the same value.
Mode
BSE, SA, TDD
Range
350 MHz to 3 GHz or 6 GHz (Depends upon license.)
Units
Hz, KHz, MHz, GHz
Preset
TDD: 1.910 GHz
Dependencies and/or Couplings This key is grayed out when Tech is set to FDD.
Frequency range depends on installed license.
Initial S/W Revision
6.0
License Type E6621A-503 = 350 MHz to 3 GHz
E6621A-506 = 350 MHz to 6 GHz
Key Path
Freq
Band
When Freq > Setting Method is set to EARFCN, this menu key sets the frequency band transmitted in SIB1
based on the tables shown below:
Table of DL EARFCN Default Values for LTE Frequency Bands (FDD Only)
Table of UL EARFCN Default Values for LTE Frequency Bands (10 MHz cells -FDD Only)
Table of UL/DL EARFCN Default Values for LTE Frequency Bands (TDD Only)
When Freq > Setting Method is set to FREQ, this menu key sets the stored value(s) of the EARFCN(s)
based on the tables referenced above.
It does not change the DL or UL frequency used by the PXT. The EARFCN values are immediately active
when you switch back to Setting Method > EARFCN.
This setting overwrites the value defined in the currently loaded scenario file, when the
BSE emulator is not running (Mode > BSE > Emulator Mode- Stop is selected).
Mode
BSE, SA
Overwrites Scenario File Value
Yes
Range FDD: 1 to 32
TDD: 33 to 64
Preset FDD: 1
TDD: 33
Initial S/W Revision
6.3
Key Path
Freq