User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
33
UL Timing Offset Adjustment
Provides a manual offset adjustment for the uplink timing, to ensure the signal is captured by the PXT.
For configurations involving fading, it is possible that the uplink signal may be delayed relative to the
expected start position. This setting compensates for this delay.
If you are using large delays in fading, this parameter is necessary in order to connect to the PXT.
Mode
BSE, SA
Range
-100 to +100 us
Units
sec, ms, us
Preset
0 us
Initial S/W Revision
6.4
Key Path
Mode > BSE/SA > Config > General Config
Admin
This key applies to service centers only.
Mode
BSE, SA
Initial S/W Revision
6.4
Key Path
Mode > BSE/SA > Config
Cont
Sets the PXT for continuous measurement operation. The single/continuous state is only effective when you
are in SA mode. If you are in Single mode, pressing Cont causes the measurement operation to resume.
Mode
SA
Initial S/W Revision
6.0
Key Path
Front-panel key
Freq – Key Menu 1
Accesses the menu enabling you to set the UL and DL frequencies.
Setting Method
Center (DL) Freq
Center (UL) Freq
Center (UL/DL) Freq
Band
DL EARFCN
UL EARFCN
UL/DL EARFCN
Key Path: Front-panel key