User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
24
PXT Connections
Displays the current value for PXT IP Address #1 and accesses the key menu that enables you to change
this address and/or connect to the EPC.
Initial S/W Revision
6.4
Key Path
Config > Network Setup > EPC Setup
PXT IP Address #1
With each key press, a different IP address segment (delineated by a period) is underlined. When the
desired segment is underlined, set the numeric value using the front-panel numeric keypad and select
Enter.
Initial S/W Revision
6.4
Key Path
Config > Network Setup > EPC Setup > PXT Connections
External EPC
Enables you to connect or disconnect to the external EPC.
‘Connect’must be selected when using the EPC. For more information about using the EPC refer to
EPC
on page 85 and EPC Setup on page 144.
Initial S/W Revision
6.4
Key Path
Config > Network Setup > EPC Setup > PXT Connections
Cell Setup
Accesses the menus enabling you to setup the following parameters:
A-Cell Ratio
B-Cell Ratio
Cell Selection
Key Path: Config
A-Cell Ratio
Selects the ratio in percent of the relative power allocated to A-cell compared to B-cell. For example, if A-
cell is set to 80%, then B-cell is set to 20%.
Mode
BSE, SA
Range
0 to 100
Units
%
Preset
100%
Dependencies and/or Couplings
This setting is coupled to B-Cell Ratio.
Initial S/W Revision
6.0
Key Path
Config > Cell Setup