User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
23
OK
After designating all the necessary IP addresses above, press this key to activate these settings. Changes
to the IP configuration will not take effect until the OK key is pressed.
Key Path: Config > Network Setup > IP Setup
Remote Ctrl Setup
This key accesses the menus to configure remote control of the PXT using either .DLL or GPIB.
The settings in this menu are all persistent through an instrument power cycle.
Key Path: Config > Network Setup
TCP/IP
Accesses the key menu that enables you to specify and activate TCP/IP port.
Key Path: Config > Network Setup > Remote Control Setup
Port
Specifies the port number used to control the PXT if remote control is to be performed over TCP/IP.
The port number specified here must match that used in the E6621_Connect command (one of the API
commands supported by the E6621A Remote API DLL).
Key Path: Config > Network Setup > Remote Control Setup > TCP/IP
GPIB
Accesses the key menu that enables you to specify and activate the GPIB address.
This setting is persistent through an instrument power cycle.
Key Path: Config > Network Setup > Remote Control Setup
GPIB Address
Specifies the GPIB address used to control the PXT if remote control is to be performed over GPIB.
Key Path: Config > Network Setup > Remote Control Setup > GPIB
EPC Setup
Accesses the settings that enable you to use the EPC. For more information, see EPC Setup on page 144.
Mode
BSE, SA
Initial S/W Revision
6.4
Key Path
Config > Network Setup