User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
21
Ext Cell Select
You must select External, by pressing BSE > Config > RF Output Control > RF DL
Output to enable the functionality of this key.
A-Cell: Enables external processing (for example: fading) of internally generated IQ signals, as described in
RF DL Output
, above.
B-Cell: Enables an external signal to be injected into B-Cell via the I/IF INPUT and Q/IF INPUT BNCs,
where it is processed and pushed back out through the IQ OUTPUT BNCs.
Mode
BSE
Range
A-Cell | B-Cell
Preset
B-cell
Initial S/W Revision Menu key present at 6.0.
SCPI command introduced at 6.3
Key Path
Config > RF Setup > RF Output Control
Ref. Clock Source
Auto enables the timing synch to come from external or internal (the E6621A PXT) sources. The blocks at
the top-right of the display indicate external (EXT) or internal (INT) in yellow to show these conditions are
met.
Internal sets the timing synch to come from inside the PXT. If you connect an external clock source, it will
disregard it and continue to use the internal clock as the reference.
Key Path: Config > RF Setup
Network Setup
This menu key accesses the topics that enable you to configure your network.
IP Setup
Remote Ctrl Setup
EPC Setup
Key Path: Config
IP Setup
Internet Protocol (IP) setup enables you to set the IP addresses for the following components.
IP
Netmask
Gateway
DNS
OK
All parameters set in this menu are persistent through an instrument power cycle.
Key Path: Config > Network Setup