User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
20
Ext Cell Select
Refer to RF Measurements
section for more information on the menus below.
Key Path: Config > RF Setup
RF DL Output
Enables external processing of the IQ signals (for example: fading) before RF up-conversion takes place.
There are four BNC outputs associated with this menu key: I1 OUTPUT, Q1 OUTPUT, I2 OUTPUT, and
Q2 OUTPUT. The corresponding inputs are: I1 RETURN, Q1 RETURN, I2 RETURN, and Q2 RETURN.
Mode
BSE, SA
Range
Int | Ext
Preset
Int
Initial S/W Revision
6.0
Key Path
Config > RF Setup > RF Output Control
RF1 Front Output
TRX: Indicates that the DL RF1 Output is present on the antenna port labeled RF1 Input/Output.
TX: Indicates that the DL RF1 Output is present on the antenna port labeled RF1 Output.
Mode
BSE, SA
Range
TRX | TX
Preset
TRX
Initial S/W Revision
6.0
Key Path
Config > RF Setup > RF Output Control
RF2 Front Output
TRX: Currently not available because RF2 Input/Output is not available.
TX: Indicates that the DL RF2 Output is present on the antenna port labeled RF2 Output.
Mode
BSE, SA
Range
TRX | TX
Preset
TRX
Initial S/W Revision
6.0
Key Path
Config > RF Setup > RF Output Control