User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
195
If a call is made to the BSE using the default BSE settings, then the default measurement settings match and
no further measurement setting changes are required.
General Purpose Measurements
Key Path:
SA > Spectrum
This section describes the general purpose measurements available in the PXT. These measurements
allow more flexible selection of parameters than the specific LTE measurements.
• Spectrum Measurement
• Channel Power Measurement
• Occupied Bandwidth Measurement
• Complementary Cumulative Distribution Function (CCDF) Measurement
The general settings described above are sufficient to make the General Purpose measurements. The
following descriptions assume that the frequency, reference level and system bandwidth have been
correctly set, and that the trigger source is set to Internal and that the trigger delay is set to 0 ms.
Spectrum Measurement
Key Path: Mode > SA > Spectrum Analyzer > MEAS > Spectrum
Figure 6-1: Spectrum measurement