User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
156
During installation the appropriate shortcuts are created under All Programs, Agilent PXT, Agilent PxtVsa
Communicator as well as on the PC desktop to launch the application.
In addition, there is an on-line help file accessible from the Help tab (F1) of the PXT/VSA software user
interface at any time.
Controlling PXT in Live Mode
After you have installed the PXT-Communicator software, start the application from the desktop short-cut
provided. The initial screen is shown below:
Figure 4 – 1: PXT-VSA Communicator Control Screen
Follow these instructions to begin using the software in real-time analysis mode.
On the PXT-Communicator user interface, perform the following:
1. Configure the IP Addresses:
a. VSA IP address of the host PC: Insert address in green circled box in above figure.
b. PXT IP address: Insert address in lower green circled box in above figure.
2. Start Server PC.
On the PXT perform the following:
3. Connect the UE to the PXT. (Mode > BSE > Run)