User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
149
E2E Setup and Benchmarking Guide
Typical E2E Test Setup Overview:
Figure 3 -5: E2E Test Setup
Component
IP
Subnet Mask
Default Gateway
Server PC
192.168.1.230
255.255.255.0
192.168.1.60
PXT
192.168.1.60
255.255.255.0
192.168.1.230
Client PC 192.168.1.51 255.255.255.0
1.
The UE IP address is assigned upon connection by the PXT via the scenario file.
This can be modified on the PXT user-interface if required.
2. In this E2E Setup and Benchmarking Guide section of this user’s manual, the
server and client components in the above diagram are referenced as follows:
a. Server PC = PXT Server or PXT default gateway server
b. Client PC = UE Host or UE Host Client PC
3. ‘Iperf’, shown in the above diagram, is a widely used tool for measuring IP
network performance. Agilent does not distribute or supply ‘Iperf’ applications. It
is expected that you will install an appropriate ‘Iperf’ application on the Server
PC and on the UE/UE Host Client PC.