User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
128
Cause Code State
Controls whether the Activate Default EPS Bearer Context Request message contains a Cause Code
(which usually indicates a requested service is not available).
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
On | Off
Preset
Off
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1(- #4) > More
Cause Code
Controls the cause code that is contained in the Activate Default EPS Bearer Context Request message, if
you have set Cause Code State to On.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
V4Only | V6Only
Preset
V4Only
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4) > More
Default EPS Bearer Config #2
Accesses the same configuration menu keys described for Default EPS Bearer Config #1 - Key Menu,
except this key enables configuration of the second Default EPS Bearer. The EPS Bearer Identity of the
context is dependent on the content of the second Activate Default EPS Bearer Context Request message
present in the scenario. For the scenario files that accompany your new PXT or upgraded software, this is
generally EPS Bearer ID 9.
Mode
BSE, FDD
Overwrites Scenario File Value All parameter values accessed via this menu key overwrite the values
in the scenario file.
Range You cannot change this value. This key only accesses lower level
configuration parameters.
Preset
EPS Bearer ID 9
Dependencies and/or Couplings You must have a scenario file loaded that defines EPS Bearer ID 9, but
not running in order to access this key menu.
Initial S/W Revision
6.4
Key Path
BSE > Mode Setup> More > NAS Settings