User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
127
P-CSCF Address Type
Sets the type of IP address you wish to use for the P-CSCF server if you have set P-CSCF State to On.
Mode
BSE
Overwrites Scenario File Value
Yes
Range
IPv4 | IPv6 | IPv4v6
Preset
IPv4
Dependencies and/or Couplings • You must have a scenario file loaded (but not running) that
defines the particular EPS Bearer ID value for which you wish to
configure.
•
P-CSCF must be set to On.
Initial S/W Revision
6.5
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4) > More
V4 P-CSCF Address
Controls the IPv4 address that is assigned as the IP address of the P-CSCF server if you have set P-CSCF
State to On.
Mode
BSE
Overwrites Scenario File Value
Yes
Range
IPv4 IP address range
Preset
0000 0000 0000 0000 0000 0000 0000 0000
Dependencies and/or Couplings • You must have a scenario file loaded (but not running) that
defines the particular EPS Bearer ID value for which you wish to
configure.
•
P-CSCF must be set to On.
Initial S/W Revision
6.5
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4) > More
V6 P-CSCF Address
Controls the IPv6 address that is assigned as the IP address of the P-CSCF server if you have set P-CSCF
State to On.
Mode
BSE
Overwrites Scenario File Value
Yes
Range
IPv6 IP address range
Preset
0000 0000 0000 0000 0000 0000 0000 0000
Dependencies and/or Couplings • You must have a scenario file loaded (but not running) that
defines the particular EPS Bearer ID value for which you wish to
configure.
• P-CSCF must be set to On.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4) > More