User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
125
DNS Address Type
Controls what type of IP address (IPv4, IPv6 or IPv4v6) is assigned as a DNS address in the Activate
Default EPS Bearer Context Request message.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
IPv4, IPv6, IPv4v6
Preset
IPv4
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)
V4 DNS Address
Controls the IPv4 address that is assigned as a DNS address in the Activate Default EPS Bearer Context
Request message, if the DNS Address Type selection and DNS State have enabled this.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
IPv4 address range
Preset
8.8.8.8
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
You must have IPv6 or IPv4v6 selected from DNS Address Type menu
key.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)
V6 DNS Address
Controls the IPv6 address that is assigned as a DNS address in the Activate Default EPS Bearer Context
Request message, if the DNS Address Type selection and DNS State have enabled this.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
IPv6 address range
Preset
0000 0000 0000 0000 0000 0000 0000 0000
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
You must have IPv6 or IPv4v6 selected from DNS Address Type menu
key.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)