User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
124
V4 Address
Controls the IPv4 address that is assigned to the UE in the Activate Default EPS Bearer Context Request
message, if you have selected this option, using the IP Address Type menu key selection above.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
V4 IP address range
Preset
000.000.000.000
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)
V6 Address
Controls the IPv6 address that is assigned to the UE in the Activate Default EPS Bearer Context Request
message, if you have selected this option, using the IP Address Type menu key selection above.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
V6 IP address range
Preset
0000.0000.0000.0000
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)
DNS State
Controls whether a DNS address is assigned to the UE in the Activate Default EPS Bearer Context Request
message.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
On | Off
Preset
Off
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)