User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
123
Default EPS Bearer Config #1 - Key Menu 1
This enables the EPS Bearer ID associated with each of the configured Default EPS Bearer Contexts in the
scenario file to be read back.
Default EPS Bearer Config #1 is always the one contained inside the Attach Accept message, which
contains an Activate Default EPS Bearer Context Request. The EPS Bearer Identity associated with this
context is set to ‘5’ in the scenario files supplied by default with the PXT.
Other Default EPS Bearer Config menus exist if there are other RRC Connection Reconfiguration messages
in the scenario file containing an Activate Default EPS Bearer Context Request message. The EPS Bearer
IDs for these may vary depending on the content of these messages. The scenario files provided with your
purchase of the PXT contain a second Default EPS Bearer Config, with EPS Bearer Identity ‘9’.
The parameters described below are present in each of the Default EPS Bearer Config menus.
Mode
BSE, FDD
Overwrites Scenario File Value All parameter values accessed via this menu key overwrite the values
in the scenario file.
Range You cannot change this value. This key only accesses lower level
configuration parameters.
Preset
EPS Bearer ID 5
Dependencies and/or Couplings You must have a scenario file loaded that defines EPS Bearer ID 5, but
not running in order to access this key menu.
Initial S/W Revision
6.4
Key Path
BSE > Mode Setup> More > NAS Settings
IP Address Type
Controls what type of IP address is assigned to the UE in the Activate Default EPS Bearer Context Request
message. You can assign an IPv4 address, an IPv6 address, or both an IPv4 and IPv6 to the UE.
Mode
BSE, FDD
Overwrites Scenario File Value
Yes
Range
IPv4, IPv6, IPv4v6
Preset
IPv4
Dependencies and/or Couplings You must have a scenario file loaded (but not running) that defines
the particular EPS Bearer ID value for which you wish to configure.
Initial S/W Revision
6.4
Key Path BSE > Mode Setup> More > NAS Settings > Default EPS Bearer
Config #1 (- #4)