User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
3
Power Requirements
Input Voltage Range: 100 to 240 VAC, automatic selection
Input Frequency Range: 50/60Hz
Input Current Rating: 5A @ 240 VAC (maximum)
7A @ 100 VAC (maximum)
WARNING
This is a Safety Class 1 Product (provided with a protective earthing ground
incorporated in the power cord). The mains plug shall only be inserted in a socket
outlet provided with a protective earth contact. Any interruption of the protective
conductor inside or outside of the instrument is likely to make the instrument
dangerous. Intentional interruption is prohibited. (IEC 348 clauses 17.3.3c & 17.3.4)
CAUTION
This instrument has an auto-ranging line voltage input. Ensure the supply voltage is
within the specified range.
When installing the product in a cabinet the convection into and out of the product
must not be restricted. The ambient temperature (outside the cabinet) must be less
than the maximum operating temperature of the product by 4° C for every 100 watts
dissipated in the cabinet. If the total power dissipated in the cabinet is greater than
800 watts, then forced convection must be used. It is your responsibility to ensure
the ambient temperature does not exceed the rated ambient temperature stated in
the specification.
PXT Software Applications
Agilent N6050A LTE Mobile Test Software
This software application comes installed as a standard product on the PXT. It is the basis for all UE
testing. N6050A-7FP provides LTE-FDD base station emulation and N6050A-8FP provides LTE-TDD base
station emulation.
Agilent N6051A LTE RF Parametric Test with Test Mode Signaling
This software application is useful for RF design. It is installed in the PXT and includes a suite of LTE RF
measurements that are used for characterization, calibration, and verification purposes, available while on
a connection. This software application is optional.
Agilent N6052A LTE Functional and Application Test
This software application enables the PXT to provide a controlled environment where you can verify
network attach, idle and connected mode operation and functional performance such as throughput.
Maximum flexibility makes it possible for you to configure a range of connection and network parameters
where you can test, stress, and debug the protocol and data handling capabilities of designs including DL
2x2 MIMO and handovers. This software application is optional.