User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
101
Type0 Bitmap
When using Resource Allocation Type 0 (see 3GPP 36.213, section 7.1.6.1), this bitmap indicates the
resource block groups that are allocated to the UE.
This field is only available when using TM3, TM4, TM6, and TM7 (which use Resource Allocation Type 0).
Mode
BSE
Range 0x00000000 – 0x0000003F (1.4 MHz)
0x00000000 – 0x000000FF (3 MHz)
0x00000000 – 0x00001FFF (5 MHz)
0x00000000 – 0x0001FFFF (10 MHz)
0x00000000 - 0x0007FFFF (15 MHz)
0x00000000 – 0x01FFFFFF (20 MHz)
Preset FDD:(N_PRB=50)
0x0001FFFF
TDD: (N_PRB=50)
0x0001FFFF
Dependencies and/or Couplings
Only available in TM3, TM4, TM6, and TM7
Initial S/W Revision • This menu key was introduced in 6.0
• Changed preset in 6.3
• Added TM6 in 6.4
•
Added TM7 in 6.5 (TDD only)
Key Path Mode > BSE > Mode Setup > More > PHY Settings > DL Resource
Allocation
Subframe #5 Control
This controls the usage of subframe number five regarding the transmission of System Information and UE
Specific transmissions. There are three possible options.
1. Radio Conformance Tests state that subframe five must always be reserved for System
Information and not used for UE specific transmissions.
2. Default operation is to use subframe five for UE specific transmissions only when it is not being
used for System Information.
3. For Maximum Throughput, after a connection has been established, subframe five can be used for
UE specific transmissions and not for System Information.
Mode
BSE
Range
Default | Max Th | RCT
Preset
Default
Dependencies and/or Couplings
When set to Max Th, connection timer functions are not available.
Initial S/W Revision
6.0
Key Path Mode > BSE > Mode Setup > More > PHY Settings > DL Resource
Allocation