User`s guide

Agilent PXT Wireless Communications Test Set
User’s Guide
94
RB Start
Sets the starting resource block used for the uplink allocation where a semi-persistent scheduling
allocation is being used.
This parameter is referenced as
START
RB
in 3GPP 36.213, section 8.1.
Mode
BSE, FDD
Range 0 – 5 (1.4 MHz Bandwidth)
0 – 14 (3 MHz Bandwidth)
0 – 24 (5 MHz Bandwidth)
0 – 49 (10 MHz Bandwidth)
0 – 74 (15 MHz Bandwidth)
0 – 99 (20 MHz Bandwidth)
Preset
0
Initial S/W Revision
6.4
Key Path Mode > BSE > Mode Setup > More > PHY Settings > UL Resource
Allocation > SPS Config
RCT
Accesses the menu that enables you to configure the UL Resource Allocation parameters used in
performing Radio Conformance Testing.
Key Path: BSE > Mode Setup > More > PHY Settings > UL Resource Allocation
UL Tx Pattern
Sets one of the following subframe uplink transmission patterns:
All: All subframes (TDD and FDD)
SF2: Only subframe two (TDD and FDD)
SF3: Only subframe three (FDD only)
SF0/5: Only subframe 0 or five (FDD only)
SF1/3/5/7: Only subframe one, three, five, or seven (FDD only)
SF3/8: Only subframe three or eight (TDD and FDD)
Mode
BSE
Range
ALL, SF2, SF3, SF0/5, SF1/3/5/7, SF3/8
Preset
ALL
State Saved
No
Initial S/W Revision
6.1 (Added SF2, SF1/3/5/7, and SF3/8 in 6.3)
Key Path Mode > BSE > Mode Setup > More > PHY Settings > UL Resource
Allocation > RCT