User`s guide

Base Station Emulator Mode 3
E6651A User’s Guide 51
Figure 27 Setting window after selecting Neighbor. 3/3
Handover Setting Parameter
The available menu functions are as follows:
MOB_NBR- ADV msg - Configure parameters in
MOB_NBR- ADV message, one of hand over test functions.
•Operator ID - Select Operator ID parameter. Shared by
several E6651As as Common ID.
• Neighbor #1 - Configuring Neighbor #1 information. (The
same parameters can be configured for Neighbor #2 and
#3.)
• BS ID - Select Neighbor BS ID. Minimum 24 bits base
station Id parameter information in DL- MAP message.
• DCD CC - Select DCD CC parameter. DCD CC is “DCD
Configuration Change Count” and SS can get
information on whether neighbor BS's DCD parameters
are changed or not. Upon DCD parameters change, the
count number will be changed accordingly.
• UCD CC - Select UCD CC parameter. UCD CC is “UCD
Configuration Change Count” and SS can get
information on whether neighbor BS's UCD parameters
are changed or not. Upon UCD parameters change, the
count number will be changed accordingly.