User`s guide

Getting Started 2
E6651A User’s Guide 27
Operational Mode Selection
When the application has loaded completely, the Operational
Mode Selection Window, shown in Figure 9, is displayed.
Figure 9 E6651A Test Set Operational Mode Selection Window
Press the Mode button on the Front Panel to display the
Operational Mode Selection Menu on the right side of the
screen. The three operational modes available are:
BS Emulator (Base Station
Emulator)
Press this button to select BSE mode. In this mode, the Test
Set simulates a standard Mobile WiMAX base station for air
interface and subscriber station communication testing.
Signal Analyzer (Mobile
WiMAX Signal Analyzer)
Press this button to select SA mode. Alternatively, press the
Measure button on the Front Panel for SA mode operation.
In this mode, the Test Set performs spectrum analysis and
modulation analysis for standard Mobile WiMAX signals.
Signal Generator (Mobile
WiMAX Signal Generator)
Press this button to select SG mode. In this mode, the Test
Set transmits a standard Mobile WiMAX signal stored in
memory. You can choose from among several signals and
adjust the output power of the signal.
Refer to Figure 6 on page 24 for details of the menu
structure for each operational mode.