User`s guide

Appendix A - Network Entry Procedure A
E6651A User’s Guide 173
The flow diagram in Figure 44 depicts the general Network
Entry procedure of the SS. “Network Entry Procedure
Detail" on page 174 provides detail on each step in the
Network Entry procedure.
Figure 44 Initial Network Entry Procedure of the SS
UL/DL-MAP Broadcast: PHY Sync Field, Operation ID, Sector ID,
MAP message length
SS Scans for DL
Channel
→ DL Synch
SS
BS
DCD Broadcast: BS Power, PHY type, DL burst profile, Moderation
Type, FEC, PHY Synch, BSID
UCD Broadcast: PHY Synch Field, BSID, PHY Specs
Obtain UL Parameters
Range-REQ: Requested DL Burst Profile, SS MAC Addr, Ranging
Anomalies, SS Broadcast Capabilities
Range-RSP: Timing Adjust, Pwr lvl Adjust, Freq Offset Adjust,
Ranging Status, DL Freq Override, LL Freq Override, Burst Profile,
SS MAC addr, CID, .........
Ranging and Adjust
Parameters
SBC-REQ: CID, PHY params supported, Bandwidth allocations
supported
SBC-RSP: CID, PHY params supported, Bandwidth allocations
supported
Negotiate Basic
Capabilities
REG-REQ: CID, Hashed Msg Auth Code, IP vers, Vendor ID, CS
capability, ARQ params
REG-RSP: CID, OK/Not, HMAC tuple, IP vers, Vendor ID, CS
capability, ARQ params
Register with BS
Ranging Code for Initial Ranging
Ranging Code for BW Request