Technical data

78 Chapter 6
Front Panel Sequence Setup
Front Panel List Sequencer Setup
Front Panel Sequence Setup
Front Panel List Sequencer Setup
This chapter shows how to create a sequence (or modify parameters of an existing sequence) from the
front panel of the test set. You can then save the sequence to a file using the Save menu. (To recall a
previously saved sequence see “Save and Recall” on page 75).
NOTE Setting up a sequence from the front panel does not provide access to the full flexibility of
the list sequencer (for that, it is preferable to use a spreadsheet to set up the sequence, as
described in Chapter 7 , “List Sequencer Spreadsheet Data Entry,” on page 91).
Prior to setting up an acquisition and analysis intervals, the measurement, mode, and list sequencer
global parameters as described in Chapter 5 , “Mode Parameters,” on page 53, should be set up. The
mode and measurement parameters cannot be set up from the front panel in Sequence Analyzer mode,
but can be set up from the front panel if you are in the required measurement mode. For example, if you
are running GSM/EDGE measurements in the Sequence Analyzer mode, change to the GSM/EDGE
mode to set up the GSM/EDGE mode and measurement parameters from the front panel; then return to
the Sequence Analyzer mode and follow the process described below.
Select mode
To use the list sequencer you need to be in the Sequence Analyzer mode. To change to this mode proceed
as follows:
Step 1. Press the
Mode hardkey.
Step 2. Press
Sequence Analyzer softkey.
Figure 6-1 Mode selection