Technical data

Chapter 5 75
Mode Parameters
Save and Recall
Mode Parameters
Save and Recall
If you have set up a sequence, you can save it either from the front panel or by remote control. From the
front panel, press the
Save hardkey and then, select the Sequences, Save As... menu. The Save,
Sequences
menu requires that you select whether the type of sequence you are saving is a source
sequence, an analyzer sequence or a source and analyzer sequence and in the
Save As... menu the
automatically generated filename is specific to the selected save type.
Figure 5-3. Save a Sequence
The remote control SCPI command for this feature is
:MMEM:STORe:SEQuences:|SLISt|ALISt|SAAList “MySequence.txt”
This command saves the sequence that is currently set up in the test set. You must select whether you are
saving a source list sequence, an analyzer list sequence, or a source and analyzer list sequence. The
default directory where the file is saved is on the D drive in My Documents\Sequences.
You can use the
Recall, Sequences on the front panel, followed by the Recall, Sequences, Open...
menu to load a sequence file into the list sequencer from a directory.