Technical data

Chapter 5 69
Mode Parameters
Advanced Setup Parameters
Mode Parameters
Loopback BER Threshold, GSM
This parameter allows you to specify the threshold level used in GSM Loopback BER calculation. If the
BER is below the threshold level, then this result will be available to be accumulated; if above, it will be
ignored.
:SERVice[:PRODuction]:LSEQuencer:ADVanced:GSM:LBER:DISCard <real>
Loopback BER Threshold, EDGE
This parameter allows you to specify the threshold level used in EDGE Loopback BER calculation. If
the BER is below the threshold level, then this result will be available to be accumulated; if above, it will
be ignored.
:SERVice[:PRODuction]:LSEQuencer:ADVanced:EDGE:LBER:DISCard <real>
LTE-FDD Specifc Setup Parameters
LTE-FDD Channel Condition
LTE-FDD Channel Condition determines the limit value of LTE-FDD spectrum flatness (Pass/Fail
results of RP1, PR2 RP12 and RP21).
:SERVice[:PRODuction]:LSEQuencer:ADVanced:LTE:CCONdition NORMal|EXTReme
:SERVice[:PRODuction]:LSEQuencer:ADVanced:LTE:CCONdition?
LTE-TDD Specifc Setup Parameters
LTE-TDD Channel Condition
LTE-TDD Channel Condition determines the limit value of LTE-TDD spectrum flatness (Pass/Fail
results of RP1, RP2, RP12 and RP21).
:SERVice[:PRODuction]:LSEQuencer:ADVanced:LTETdd:CCONdition NORMal|EXTReme
:SERVice[:PRODuction]:LSEQuencer:ADVanced:LTETdd:CCONdition?
WCDMA Specifc Setup Parameters
Loopback BER Pattern, WCDMA
This parameter allows you to specify (by file or by string) the reference bits used in WCDMA Loopback
BER calculation.
:SERVice[:PRODuction]:LSEQuencer:ADVanced:WCDMa:LBER:PATTern <filepath +
filename>
:SERVice[:PRODuction]:LSEQuencer:ADVanced:WCDMa:LBER:PATTern:LOAD <String>
:SERVice[:PRODuction]:LSEQuencer:ADVanced:WCDMa:LBER:PATTern:LOAD?