Technical data

66 Chapter 5
Mode Parameters
List Sequencer Global Parameters
Mode Parameters
Abort on Error
This parameter specifies whether or not the test set aborts during a sequence if the test set returns an error
for any of the measurements in the sequence. If set to ON, this parameter causes the list sequencer to stop
at the point in the sequence where the error occurs. The current measurement may not be completed;
subsequent measurements are not started.
The remote command for this parameter is:
[:SENSe]:LSEQuencer:ABORt:ERRor[:STATe] ON|OFF|0|1
NOTE If Abort on Error is set to ON and there are any errors in the error queue, then the
measurement aborts immediately. To avoid this send *CLS or clear the error queue prior
to starting the measurement.
NOTE If the source list sequencer is running with the analyzer list sequencer, and the analyzer
list sequencer aborts due to an error, then the source list sequencer is also aborted.
Input Trigger - Video - Trig Slope
This parameter defines the polarity of the Video trigger input. For a rising edge trigger, set the slope to
Positive. For a falling edge trigger, set the slope to Negative.
The remote command for this parameter is:
:TRIGger:LSEQuencer:VIDeo:SLOPe POSitive|NEGative
Input Trigger - External Port 1 - Trig Slope
This parameter defines the polarity of the External 1 trigger input. For a rising edge trigger, set the slope
to Positive. For a falling edge trigger, set the slope to Negative.
The remote command for this parameter is:
:TRIGger:LSEQuencer:EXTernal1:SLOPe POSitive|NEGative
Input Trigger - External Port 1 - Level
This parameter defines the voltage level at the Trigger 1 In port at which triggering occurs.
The remote command for this parameter is:
:TRIGger:LSEQuencer:EXTernal1:LEVel <level>
Input Trigger - External Port 2 - Polarity
This parameter defines the polarity of the External 2 trigger input. For a rising edge trigger, set the
polarity to Positive. For a falling edge trigger, set the polarity to Negative.
The remote command for this parameter is:
:TRIGger:LSEQuencer:EXTernal2:SLOPe POSitive|NEGative