Technical data

56 Chapter 5
Mode Parameters
Mode and Measurement Parameters
Mode Parameters
GSM Burst Search Threshold
Burst Search Threshold setting for GSM mode. Sets the relative power threshold from the peak power,
which is used by the burst alignment algorithm to determine the burst rising edge and falling edge. For
more details about the command see the GSM/EDGE online help (or in pdf format, the User’s and
Programmer’s Reference).
[:SENSe]:LSEQuencer:EDGE:SYNC:BURSt:STHReshold <rel_ampl>
[:SENSe]:LSEQuencer:EDGE:SYNC:BURSt:STHReshold?
GSM HSR Pulse Shape Filter
HSR Pulse Shaping Filter setting for GSM mode. Selects the pulse shaping filter for higher symbol rate
(HSR) signals. For more details about the command see the GSM/EDGE online help (or in pdf format,
the User’s and Programmer’s Reference).
This functionality applies only to the following measurements:
• EDGE EVM Measurement
• EDGE Power vs. Time Measurement
• GMSK/EDGE Output RF Spectrum measurement
Requires EDGE Evolution U9071A-3FP to be installed.
[:SENSe]:LSEQuencer:EDGE:RADio:PSHape NARRow|WIDE
[:SENSe]:LSEQuencer:EDGE:RADio:PSHape?
GSM Burst Align
Burst Align setting for GSM mode. Selects the sync alignment to be either to the GSM standard or the
standard offset by a half bit behind. For more details about the command see the GSM/EDGE online help
(or in pdf format, the User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:EDGE:SYNC:ALIGnment GSM|HBIT
[:SENSe]:LSEQuencer:EDGE:SYNC:ALIGnment?
GSM Carrier Bandpass Filter
Carrier Bandpass Filter setting for GSM mode. Select Multiple or Single to enable or disable the
multi-carrier tolerance filter. For more details about the command see the GSM/EDGE online help (or in
pdf format, the User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:EDGE:RADio:CARRier:NUMBer SINGle|MULTiple
[:SENSe]:LSEQuencer:EDGE:RADio:CARRier:NUMBer?