Technical data

330 Chapter 21

WLAN Programming Commands

Spectrum Emissions Mask (SEM)

WLAN Programming Commands

Spectrum Emissions Mask (SEM)

This section provides the remote control SCPI commands for the WLAN Spectrum Emissions Mask

(SEM) measurement from within the List Sequencer. This measurement is available only if you have the

WLAN measurement application licensed on the test set.

For more detailed information about the SEM measurement, refer to the online help associated with the

WLAN measurement application, which is also available in PDF format (“User’s and Programmer’s

Reference”) on the Agilent website, www.agilent.com/find/e6640a.

You can also refer to the measurement guide for the X-series WLAN measurement application, which is

available on the Agilent website, www.agilent.com/find/mxa.

SEM measurement SCPI commands

There is a set of SCPI commands available to program the WLAN SEM measurement when it is used in

the WLAN mode. To set up the WLAN measurements from within the Sequence Analyzer mode you

need to prefix the SCPI commands with LSEQuencer:WLAN. For example, the [:SENSe]:SEMask

part of the SEM SCPI commands are replaced with: [:SENSe]:LSEQuencer:WLAN:SEMask

The following commands are used to set up the SEM measurement.

[:SENSe]:LSEQuencer:WLAN:SEMask:TYPE

[:SENSe]:LSEQuencer:WLAN:SEMask:BANDwidth[1]|2:INTegration

[:SENSe]:LSEQuencer:WLAN:SEMask:FREQuency[1]|2:SPAN

[:SENSe]:LSEQuencer:WLAN:SEMask:BANDwidth[1]|2:[:RESolution]

[:SENSe]:LSEQuencer:WLAN:SEMask:BANDwidth[1]|2:[:RESolution]:AUTO

[:SENSe]:LSEQuencer:WLAN:SEMask:CARRier[:POWer]

[:SENSe]:LSEQuencer:WLAN:SEMask:CARRier:AUTO[:STATe]

[:SENSe]:LSEQuencer:WLAN:SEMask:CARRier:CPSD

[:SENSe]:LSEQuencer:WLAN:SEMask:CARRier:PEAK[:POWer]

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:FREQuency:STARt

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:STATe

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:FREQuency:STOP

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:SIDE

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:BANDwidth[:RESolution]

:AUTO

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:BANDwidth:IMULti

[:SENSe]:LSEQuencer:WLAN:SEMask:OFFSet[1]|2:LIST:STARt:ABSolute