Technical data

326 Chapter 20
Bluetooth Programming Commands
LE In-band Emission
Bluetooth Programming Commands
LE In-band Emission
This section provides the remote control SCPI commands for the Bluetooth LE In-band Emission
measurement from within the List Sequencer. This measurement is available only if you have the
Bluetooth measurement application licensed on the test set.
For more detailed information about the CDP measurement, refer to the online help associated with the
Bluetooth measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series Bluetooth measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
LE In-band Emission measurement SCPI commands
There is a set of SCPI commands available to program the Bluetooth LE In-band Emission measurement
when it is used in the Bluetooth mode. To set up the Bluetooth measurements from within the Sequence
Analyzer mode you need to prefix the SCPI commands with LSEQuencer:BTooth. For example, the
[:SENSe]:IBEMissions part of the LE In-band Emission SCPI commands are replaced with
[:SENSe]:LSEQuencer:BTooth:IBEMissions.
The following commands are used to set up the LE In-band Emission measurement.
:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:STATe
:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:FAR:UPPer[:DATA]
:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:NEAR:UPPer[:DATA]
[:SENSe]:LSEQuencer:BTooth:IBEMissions:FREQuency:SPAN