Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsComputer AccessoriesE6640A EXM
321322323324325326327328329330
Chapter 20 323
Bluetooth Programming Commands
Modulation Accuracy (Transmit Analysis)
Bluetooth Programming Commands
Modulation Accuracy (Transmit Analysis)
This section provides the remote control SCPI commands for the Bluetooth Modulation Accuracy
(Transmit Analysis) measurement from within the List Sequencer. This measurement is available only if
you have the Bluetooth measurement application licensed on the test set.
For more detailed information about the Modulation Accuracy measurement, refer to the online help
associated with the Bluetooth measurement application, which is also available in PDF format (“User’s
and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series Bluetooth measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Modulation Accuracy measurement SCPI commands
There is a set of SCPI commands available to program the Bluetooth Modulation Accuracy (Transmit
Analysis) measurement when it is used in the Bluetooth mode. To set up the Bluetooth measurements
from within the Sequence Analyzer mode you need to prefix the SCPI commands with
LSEQuencer:BTooth. For example, the [:SENSe]:TX part of the modulation accuracy SCPI
commands are replaced with: [:SENSe]:LSEQuencer:BTooth:TX
The following commands are used to set up the modulation accuracy measurement.
[:SENSe]:LSEQuencer:BTooth:TX:BSYNc PREamble|RAMPtd|NONE
:CALCulate:LSEQuencer:BTooth:TX:LIMit:STATe
:CALCulate:LSEQuencer:BTooth:TX:OPOWer:LIMit:AVERage:UPPer
:CALCulate:LSEQuencer:BTooth:TX:OPOWer:LIMit:AVERage:LOWer
:CALCulate:LSEQuencer:BTooth:TX:OPOWer:LIMit:PEAK:UPPer
:CALCulate:LSEQuencer:BTooth:TX:ICFT:LIMit:UPPer
:CALCulate:LSEQuencer:BTooth:TX:ICFT:LIMit:LOWer
:CALCulate:LSEQuencer:BTooth:TX:MCHar:LIMit:DF1:AVERage:UPPer
:CALCulate:LSEQuencer:BTooth:TX:MCHar:LIMit:DF1:AVERage:LOWer
:CALCulate:LSEQuencer:BTooth:TX:MCHar:LIMit:DF2:MAX:LOWer
:CALCulate:LSEQuencer:BTooth:TX:MCHar:LIMit:RATio:LOWer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH1:DRIFt:UPPer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH1:DRIFt:LOWer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH1:RATE:UPPer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH1:RATE: LOWer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH3:DRIFt:UPPer
:CALCulate:LSEQuencer:BTooth:TX:CFDRift:LIMit:DH3:DRIFt:LOWer