Technical data

Chapter 20 321
Bluetooth Programming Commands
Occupied Bandwidth (OBW)
Bluetooth Programming Commands
Occupied Bandwidth (OBW)
This section provides the remote control SCPI commands for the Bluetooth Occupied Bandwidth
(OBW) measurement from within the List Sequencer. This measurement is available only if you have the
Bluetooth measurement application licensed on the test set.
For more detailed information about the OBW measurement, refer to the online help associated with the
Bluetooth measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series Bluetooth measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
OBW measurement SCPI commands
There is a set of SCPI commands available to program the Bluetooth OBW measurement when it is used
in the Bluetooth mode. To set up the Bluetooth measurements from within the Sequence Analyzer mode
you need to prefix the SCPI commands with LSEQuencer: Bluetooth. For example, the
[:SENSe]:OBWidth part of the OBW SCPI commands are replaced with
[:SENSe]:LSEQuencer:BTooth:OBWidth.
The following commands are used to set up the OBW measurement.
[:SENSe]:LSEQuencer:BTooth:OBWidth:BANDwidth[:RESolution]
[:SENSe]:LSEQuencer:BTooth:OBWidth:BANDwidth:SHAPe
[:SENSe]:LSEQuencer:BTooth:OBWidth:PERCent
[:SENSe]:LSEQuencer:BTooth:OBWidth:XDB
CALCulate:[SENSe]:LSEQuencer:BTooth:OBWidth:LIMit:FBLimit
CALCulate:[SENSe]:LSEQuencer:BTooth:OBWidth:LIMit[:TEST]
[:SENSe]:LSEQuencer:BTooth:OBWidth:FREQuency:SPAN
[:SENSe]:LSEQuencer:BTooth:OBWidth:FREQuency:SPAN:FULL
[:SENSe]:LSEQuencer:BTooth:OBWidth:FREQuency:SPAN:PREVious