Technical data

320 Chapter 20
Bluetooth Programming Commands
Adjacent Channel Power (ACP)
Bluetooth Programming Commands
Adjacent Channel Power (ACP)
This section provides the remote control SCPI commands for the Bluetooth Adjacent Channel Power
(ACP) measurement from within the List Sequencer. This measurement is available only if you have the
Bluetooth measurement application licensed on the test set.
For more detailed information about the ACP measurement, refer to the online help associated with the
Bluetooth measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series Bluetooth measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Adjacent Channel Power (ACP) measurement SCPI commands
There is a set of SCPI commands available to program the Bluetooth ACP measurement when it is used
in the Bluetooth mode. To set up the Bluetooth measurements from within the Sequence Analyzer mode
you need to prefix the SCPI commands with LSEQuencer:BTooth. For example, the
[:SENSe]:ACPower part of the ACP SCPI commands are replaced with
[:SENSe]:LSEQuencer:BTooth:ACPower.
The following commands are used to set up the ACP measurement.
:CALCulate:LSEQuencer:BTooth:ACPower:LIMit:STATe
:CALCulate:LSEQuencer:BTooth:ACPower:LIMit:FAR:UPPer[:DATA]
:CALCulate:LSEQuencer:BTooth:ACPower:LIMit:NEAR:UPPer[:DATA]
[:SENSe]:LSEQuencer:BTooth:ACPower:FREQuency:SPAN
ACP results
Index Result Parameter
0 Overall Pass/Fail
TxRefIndex
TxRefPower
AdjChanPowerUpper
AdjChanPowerLower
NumberofExceptions
1 Power Results
Returns up to 79 scalar values (comma separated) of the Tx power per channel.
The number of the meaningful results depends on the Span. And the meaningful
value were placed the head of the array.