Technical data

316 Chapter 19
TD-SCDMA Programming Commands
Code Domain Power (CDP)
TD-SCDMA Programming Commands
Code Domain Power (CDP)
This section provides the remote control SCPI commands for the TD-SCDMA Code Domain Power
(CDP) measurement from within the List Sequencer. This measurement is available only if you have the
TD-SCDMA measurement application licensed on the test set.
For more detailed information about the CDP measurement, refer to the online help associated with the
TD-SCDMA measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series TD-SCDMA measurement application,
which is available on the Agilent website, www.agilent.com/find/mxa.
Code Domain Power (CDP) measurement SCPI commands
There is a set of SCPI commands available to program the TD-SCDMA CDP measurement when it is
used in the TD-SCDMA mode. To set up the TD-SCDMA measurements from within the Sequence
Analyzer mode you need to prefix the SCPI commands with LSEQuencer:TDSCdma. For example, the
[:SENSe]:CDPower part of the CDP SCPI commands are replaced with
[:SENSe]:LSEQuencer:TDSCdma:CDPower.
The following commands are used to set up the CDP measurement.
[:SENSe]:LSEQuencer:TDSCdma:CDPower:RINTerval
[:SENSe]:LSEQuencer:TDSCdma:CDPower:ANALysis:SUBFrame
[:SENSe]:LSEQuencer:TDSCdma:CDPower:SCLength
[:SENSe]:LSEQuencer:TDSCdma:CDPower:CDCHannel