Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsComputer AccessoriesE6640A EXM
311312313314315316317318319320
312 Chapter 19
TD-SCDMA Programming Commands
Modulation Accuracy (Rho)
TD-SCDMA Programming Commands
Modulation Accuracy (Rho) results selection
This command allows you to specify which of the possible result metrics from the TD-SCDMA
Modulation Accuracy measurement are returned. The 1st (leftmost) value in the SCPI command
represents Index 0.
The “Number of Results” value returned ahead of the measurement results is dependent on the selection
made here. The result metrics that are selected by default are indexes 0-25 in the table of results for the
measurement.
This selection is set for the entire Sequence. Should you want a specific result selection returned for one
particular analysis step and not the rest, this can be achieved by using delta parameters.
20 Peak Active Code Domain Error (Peak Hold) is a floating point number (in dB) of the peak hold Peak
Active CDE (of active code channels, in average cycle) of the selected timeslot.
21 Peak Active Code Domain Error - Code Length (Peak Hold) is the code length of peak hold Peak
Active CDE (in average cycle) of the selected timeslot.
22 Peak Active Code Domain Error - Code Index (Peak Hold) is the code index of peak hold Peak Active
CDE (in average cycle) of the selected timeslot.
23 Number of active channels.
24 Time Offset (Average) is a floating point number (in chips) of the averaged composite timing error (in
average cycle) of the selected timeslot, relative to the timing reference (DwPTS/UpPTS/Trig).
Key Path
SCPI only
Remote Command [:SENSe]:LSEQuencer:TDSCdma:RHO:RESult:SELection
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1, ON|OFF|0|1,
ON|OFF|0|1
[:SENSe]:LSEQuencer:TDSCdma:RHO:RESult:SELection?
Example :LSEQ:TDSC:RHO:RES:SEL 1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1
:LSEQ:TDSC:RHO:RES:SEL?
Preset 1,1,1,1,1,1,1,1,1,1,1,1,1,1,0,1,1,1,1,1,1,1,1,1,1
Index Result Parameter