Technical data

Chapter 19 309
TD-SCDMA Programming Commands
Occupied Bandwidth (OBW)
TD-SCDMA Programming Commands
Occupied Bandwidth (OBW)
This section provides the remote control SCPI commands for the TD-SCDMA Occupied Bandwidth
(OBW) measurement from within the List Sequencer. This measurement is available only if you have the
TD-SCDMA measurement application licensed on the test set.
For more detailed information about the OBW measurement, refer to the online help associated with the
TD-SCDMA measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series TD-SCDMA measurement application,
which is available on the Agilent website, www.agilent.com/find/mxa.
OBW measurement SCPI commands
There is a set of SCPI commands available to program the TD-SCDMA OBW measurement when it is
used in the TD-SCDMA mode. To set up the TD-SCDMA measurements from within the Sequence
Analyzer mode you need to prefix the SCPI commands with LSEQuencer:TD-SCDMA. For example,
the [:SENSe]:OBWidth part of the OBW SCPI commands are replaced with
[:SENSe]:LSEQuencer:TDSCdma:OBWidth.
The following commands are used to set up the OBW measurement.
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:BANDwidth[:RESolution]
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:BANDwidth:SHAPe
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:PERCent
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:XDB
CALCulate:[SENSe]:LSEQuencer:TDSCdma:OBWidth:LIMit:FBLimit
CALCulate:[SENSe]:LSEQuencer:TDSCdma:OBWidth:LIMit[:TEST]
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:FREQuency:SPAN
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:FREQuency:SPAN:FULL
[:SENSe]:LSEQuencer:TDSCdma:OBWidth:FREQuency:SPAN:PREVious
OBW results
Index Result Parameter
0 Overall Pass/Fail
1 Main Results
1. Occupied Bandwidth (Hz)
2. Transmit Frequency Error (Hz)
3. x dB bandwidth (Hz)