Technical data

Chapter 18 281

LTE-TDD Programming Commands

Spectrum Emissions Mask (SEM)

LTE-TDD Programming Commands

Spectrum Emissions Mask (SEM)

This section provides the remote control SCPI commands for the LTE-TDD Spectrum Emissions Mask

(SEM) measurement from within the List Sequencer. This measurement is available only if you have the

LTE-TDD measurement application licensed on the test set.

For more detailed information about the SEM measurement, refer to the online help associated with the

LTE-TDD measurement application, which is also available application, which is also available in PDF

format (“User’s and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.

You can also refer to the measurement guide for the X-series LTE-TDD measurement application, which

is available on the Agilent website, www.agilent.com/find/mxa.

SEM measurement SCPI commands

There is a set of SCPI commands available to program the LTE-TDD SEM measurement when it is used

in the LTE-TDD mode. To set up the LTE-TDD measurements from within the Sequence Analyzer mode

you need to prefix the SCPI commands with LSEQuencer:LTETdd. For example, the

[:SENSe]:SEMask part of the SEM SCPI commands are replaced with:

[:SENSe]:LSEQuencer:LTETdd:SEMask

The following commands are used to set up the SEM measurement.

[:SENSe]:LSEQuencer:LTETdd:SEMask:TYPE

[:SENSe]:LSEQuencer:LTETdd:SEMask:BANDwidth[1]|2:INTegration

[:SENSe]:LSEQuencer:LTETdd:SEMask:FREQuency[1]|2:SPAN

[:SENSe]:LSEQuencer:LTETdd:SEMask:BANDwidth[1]|2:[:RESolution]

[:SENSe]:LSEQuencer:LTETdd:SEMask:BANDwidth[1]|2:[:RESolution]:AUTO

[:SENSe]:LSEQuencer:LTETdd:SEMask:CARRier[:POWer]

[:SENSe]:LSEQuencer:LTETdd:SEMask:CARRier:AUTO[:STATe]

[:SENSe]:LSEQuencer:LTETdd:SEMask:CARRier:CPSD

[:SENSe]:LSEQuencer:LTETdd:SEMask:CARRier:PEAK[:POWer]

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:FREQuency:STARt

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:STATe

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:FREQuency:STOP

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:SIDE

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:BANDwidth[:RESolution]

:AUTO

[:SENSe]:LSEQuencer:LTETdd:SEMask:OFFSet[1]|2:LIST:BANDwidth:IMULti