Technical data

274 Chapter 18
LTE-TDD Programming Commands
Power vs. Time (PvT)
LTE-TDD Programming Commands
Power vs. Time (PvT)
This section provides the remote control SCPI commands for the LTE-TDD Power vs. Time (PvT)
measurement from within the List Sequencer. This measurement is available only if you have the
LTE-TDD measurement application licensed on the test set.
For more detailed information about the PvT measurement, refer to the online help associated with the
LTE-TDD measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series LTE-TDD measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Power vs. Time (PvT) measurement SCPI commands
There is a set of SCPI commands available to program the LTE-TDD PvT measurement when it is used
in the LTE-TDD mode. To set up the GSM measurements from within the Sequence Analyzer mode you
need to prefix the SCPI commands with LSEQuencer:LTETdd. For example, the [:SENSe]:PVTime
part of the LTE-TDD PvT SCPI commands are replaced with
[:SENSe]:LSEQuencer:LTETdd:PVTime.
The following commands are used to set up the LTE-TDD PvT measurement.
[:SENSe]:LSEQuencer:LTETdd:RADio:STANdard:PRESet
B1M4|B3M|B5M|B10M|B15M|B20M
[:SENSe]:LSEQuencer:LTETdd:RADio:STANdard:PRESet?
[:SENSe]:LSEQuencer:LTETdd:PVTime:BANDwidth <freq>
[:SENSe]:LSEQuencer:LTETdd:PVTime:BANDwidth?
[:SENSe]:LSEQuencer:LTETdd:PVTime:RAMP:SEARch:LENGth <time>
[:SENSe]:LSEQuencer:LTETdd:PVTime:RAMP:SEARch:LENGth?
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:RAMP:URTime <time>
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:RAMP:URTime?
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:RAMP:DRTime <time>
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:RAMP:DRTime?
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:POFF:ULINk <real>
[:SENSe]:LSEQuencer:LTETdd:PVTime:LIMit:POFF:ULINk?
{:SENSe]:LSEQuencer:LTETdd:PVTime:THReshold:UP:STARt <rel_ampl>
[:SENSe]:LSEQuencer:LTETdd:PVTime:THReshold:UP:STARt?
[:SENSe]:LSEQuencer:LTETdd:PVTime:THReshold:UP:END <rel_ampl>
[:SENSe]:LSEQuencer:LTETdd:PVTime:THReshold:UP:END?