Technical data

Chapter 16 247
1xEV-DO Programming Commands
Modulation Accuracy (Rho)
1xEV-DO Programming Commands
Modulation Accuracy (Rho)
This section provides the remote control SCPI commands for the 1xEV-DO Modulation Accuracy (Rho)
measurement from within the List Sequencer. This measurement is available only if you have the
1xEV-DO measurement application licensed on the test set.
For more detailed information about the Modulation Accuracy measurement, refer to the online help
associated with the 1xEV-DO measurement application, which is also available in PDF format (“User’s
and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series 1xEV-DO measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Modulation Accuracy measurement SCPI commands
There is a set of SCPI commands available to program the 1xEV-DO Modulation Accuracy
measurement when it is used in the 1xEV-DO mode. To set up the 1xEV-DO measurements from within
the Sequence Analyzer mode you need to prefix the SCPI commands with LSEQuencer:EVDO. For
example, the [:SENSe]:RHO part of the modulation accuracy SCPI commands are replaced with:
[:SENSe]:LSEQuencer:EVDO:RHO
The following commands are used to set up the modulation accuracy measurement.
:CALCulate:LSEQuencer:EVDO:RHO:MS:WCODe:ORDer
:CALCULATE:LSEQuencer:EVDO:RHO:MS:IQ:COMBined[:STATe]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:RMS[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:RMS:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:PEAK[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:PEAK:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:RHO[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:RHO:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:CDERror[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:CDERror:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:FERRor[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:FERRor:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:POFFset[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:POFFset:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:ICDPower[:SUB0]
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:ICDPower:SUB2
:CALCULATE:LSEQuencer:EVDO:RHO:MS:LIMit:RRI[:SUB0]