Technical data

246 Chapter 16
1xEV-DO Programming Commands
Occupied Bandwidth (OBW)
1xEV-DO Programming Commands
Occupied Bandwidth (OBW)
This section provides the remote control SCPI commands for the 1xEV-DO Occupied Bandwidth
(OBW) measurement from within the List Sequencer. This measurement is available only if you have the
1xEV-DO measurement application licensed on the test set.
For more detailed information about the OBW measurement, refer to the online help associated with the
1xEV-DO measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series 1xEV-DO measurement application, which
is available on the the Agilent website, www.agilent.com/find/mxa.
OBW measurement SCPI commands
There is a set of SCPI commands available to program the 1xEV-DO OBW measurement when it is used
in the 1xEV-DO mode. To set up the 1xEV-DO measurements from within the Sequence Analyzer mode
you need to prefix the SCPI commands with LSEQuencer:EVDO. For example, the
[:SENSe]:OBWidth part of the OBW SCPI commands are replaced with
[:SENSe]:LSEQuencer:EVDO:OBWidth.
The following commands are used to set up the OBW measurement.
[:SENSe]:LSEQuencer:LTETdd:OBWidth:BANDwidth[:RESolution]
[:SENSe]:LSEQuencer:LTETdd:OBWidth:BANDwidth:SHAPe
[:SENSe]:LSEQuencer:LTETdd:OBWidth:PERCent
[:SENSe]:LSEQuencer:LTETdd:OBWidth:XDB
CALCulate:[SENSe]:LSEQuencer:LTETdd:OBWidth:LIMit:FBLimit
CALCulate:[SENSe]:LSEQuencer:LTETdd:OBWidth:LIMit[:TEST]
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN:FULL
[:SENSe]:LSEQuencer:LTETdd:OBWidth:FREQuency:SPAN:PREVious
OBW results
Index Result Parameter
0 Overall Pass/Fail
1 Main Results
1. Occupied Bandwidth (Hz)
2. Transmit Frequency Error (Hz)
3. x dB bandwidth (Hz)