Technical data

Chapter 16 243

1xEV-DO Programming Commands

Spectrum Emissions Mask (SEM)

1xEV-DO Programming Commands

Spectrum Emissions Mask (SEM)

This section provides the remote control SCPI commands for the 1xEV-DO Spectrum Emissions Mask

(SEM) measurement from within the List Sequencer. This measurement is available only if you have the

1xEV-DO measurement application licensed on the test set.

For more detailed information about the SEM measurement, refer to the online help associated with the

1xEV-DO measurement application, which is also available in PDF format (“User’s and Programmer’s

Reference”) on the Agilent website, www.agilent.com/find/e6640a.

You can also refer to the measurement guide for the X-series 1xEV-DO measurement application, which

is available on the Agilent website, www.agilent.com/find/mxa.

SEM measurement SCPI commands

There is a set of SCPI commands available to program the 1xEV-DO SEM measurement when it is used

in the 1xEV-DO mode. To set up the 1xEV-DO measurements from within the Sequence Analyzer mode

you need to prefix the SCPI commands with LSEQuencer:EVDO. For example, the

[:SENSe]:SEMask part of the SEM SCPI commands are replaced with:

[:SENSe]:LSEQuencer:EVDO:SEMask

The following commands are used to set up the SEM measurement.

[:SENSe]:LSEQuencer:EVDO:SEMask:TYPE

[:SENSe]:LSEQuencer:EVDO:SEMask:BANDwidth[1]|2:INTegration

[:SENSe]:LSEQuencer:EVDO:SEMask:FREQuency[1]|2:SPAN

[:SENSe]:LSEQuencer:EVDO:SEMask:BANDwidth[1]|2:[:RESolution]

[:SENSe]:LSEQuencer:EVDO:SEMask:BANDwidth[1]|2:[:RESolution]:AUTO

[:SENSe]:LSEQuencer:EVDO:SEMask:CARRier[:POWer]

[:SENSe]:LSEQuencer:EVDO:SEMask:CARRier:AUTO[:STATe]

[:SENSe]:LSEQuencer:EVDO:SEMask:CARRier:CPSD

[:SENSe]:LSEQuencer:EVDO:SEMask:CARRier:PEAK[:POWer]

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:FREQuency:STARt

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:STATe

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:FREQuency:STOP

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:SIDE

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:BANDwidth[:RESolution]

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:BANDwidth[:RESolution]:AUT

[:SENSe]:LSEQuencer:EVDO:SEMask:OFFSet[1]|2:LIST:BANDwidth:IMULti